In this video I factory reset and connect both the TP-Link WPA281 and AV500 Powerline WIFI Extenders to each other to extend my home network through the exis Open the Mi Wi-Fi app or Mi Home app and check the range extender status. If the app indicates that the signal is poor, move the range extender closer to the router and try again. Page 9 English If the signal is poor, move the range extender to another location where there are no large obstacles between the range extender and the router. First of all, you need to make sure you don't operate the speaker at will, or disconnect the phone's Bluetooth. If the distribution network still fails, you can follow the following steps to check: 2) Put the router and speaker as close as possible without walls; 3) Find another mobile phone, turn on the hot spot of the mobile phone (ensure The extender applies your settings. This can take a few minutes. The extender displays the WiFi network name (SSID) and password for each of your extender's bands. Take note of these. On a device that you plan to connect to the extender network, go to the WiFi settings and connect to the extender's new network. 2020-06-20 11:16 AM. log into your router and check to see which ip address the router assigned to the extender. use that to access the router. Current setup: CM2000-> RBE973S-> Trendnet TEG-S380-> GS716T-> pi-hole. also in AP setup: RAXE500->EAX80. 1.4gig download/100mbps upload from Xfinity. Range Extender 1 Next to Solid On 3 Relocate Set Up 1. Plug in the extender about halfway between your router and the Wi-Fi dead zone. The location you choose must be within the range of your router. 2. Wait for about 2 minutes until the LED turns solid blue. If it doesn't, relocate the extender closer to the router to achieve better signal .

how to reset mi extender